Forward Collision-Avoidance Assist (FCA) is designed to detect vehicles, pedestrians or cyclists that are directly in front of the vehicle. FCA will not detect all vehicles, pedestrians, cyclists or other objects. FCA will not work on winding or hilly roads, during certain weather conditions such as rain, snow, fog and any other times of limited visibility. FCA initiates full braking at speeds between 10 and 75 km/h (vehicle detection), 10 and 65 km/h (pedestrian detection) or 10 and 65 km/h (cyclist detection). FCA will not detect all vehicles, pedestrians and cyclists under certain conditions. Junction-Turning Detection (JTD) provides sound warnings if the system recognizes a potential risk of collision with an oncoming vehicle and will automatically apply brakes depending on the collision level. JTD will operate when the driver turns left, if your vehicle’s turn signal is on and vehicle speed is between 10 and 30 km/h, and oncoming vehicle’s speed is between 30 and 70 km/h. See Owner’s Manual for detailed descriptions of example conditions in which FCA may not detect a vehicle, pedestrian or cyclist, or JTD will not detect an oncoming vehicle. FCA and JTD are not substitutes for safe driving. Always check your surroundings when driving. See Owner’s Manual for further details and limitations.

Adaptive Cruise Control (ACC) with traffic stop and go is not a collision avoidance or warning device. ACC is for highway use only and should not be used in poor weather, heavy or varying traffic, or on winding or slippery roads. Driver remains responsible to slow or stop the vehicle to avoid a collision. Acceleration after the vehicle comes to a complete stop will only occur when the vehicle has been stopped for less than three seconds. See Owner’s Manual for further details and limitations. May not be exactly as shown.

Blind View Monitor (BVM) assists the driver in changing lanes by providing a live view of the blind spots on either side of the vehicle and an audible alert if another vehicle is detected. Turn signal must be activated and other system limitations apply. Do not rely exclusively on BVM. It is the driver’s responsibility to be aware of surroundings and ensure they are clear before changing lanes or directions. See Owner’s Manual for more information.

Driver Attention Warning (DAW) is only a notification system and will not influence the direction or speed of the vehicle. DAW will not prevent accidents. DAW does not replace attentive and safe driving. Always ensure that you pay careful attention while driving. See Owner’s Manual for further details and limitations.

Highway Driving Assist (HDA), when used in conjunction with Lane Following Assist and Adaptive Cruise Control with traffic stop and go, is for highway use only and can help keep the vehicle centred in its lane while maintaining a safe distance from the vehicle ahead only when the lane markings are clearly visible on the road. HDA will reduce cruise control set speed as the vehicle approaches a curve in the highway. HDA should not be used in poor weather, heavy or varying traffic or on winding or slippery roads. HDA will not work under all circumstances and on all highways and will not prevent loss of control. Driver remains responsible to slow or stop the vehicle to avoid a collision. For HDA to maintain the posted speed limit of a highway, the system must be set to the exact speed limit. Only select provincial and territorial highways will apply to this feature of the system. Driver remains at all times responsible for determining the correct speed limit and to abide by such speed limits, including in situations in which a speed limit may be altered, but such change in speed limit is not recognized by the navigation system, such as in the cases of reduced speeds in construction zones or where posted speed limits have been recently increased or decreased. Driver remains responsible for controlling the vehicle to avoid a collision or other accidents. Driver is responsible for maintaining the data of the navigation system up-to-date. HDA will only fully function when the navigation map data is available for the section of highway that is being driven on. See Owner’s Manual for further details and limitations.

Lane Following Assist (LFA) can help keep the vehicle centred in its lane only when the lane markings are clearly visible on the road. Lane Following Assist will not work under all circumstances and will not prevent loss of control. LFA is a supplemental assist, and does not replace the need for extreme care and attention by the driver. See Owner’s Manual for further details and limitations.

Never rely exclusively on Parking Collision-Avoidance Assist — Rear. It is not a substitute for attentive driving. Driver remains responsible to slow or stop the vehicle to avoid a collision. Always look over your shoulder and use your mirrors when reversing to confirm safety. There are limitations to the function, detection, range and clarity of the system. It will not detect every object or vehicle and will not always avoid a collision. It will not operate if sensors are obscured. System does not activate unless vehicle is in reverse and is travelling 10 km/h or less. See Owner’s Manual for further details and limitations.

Never rely exclusively on Rear Cross-Traffic Collision-Avoidance Assist; it is not a substitute for attentive driving or the driver using the brakes to avoid a collision. Always look over your shoulder and use your mirrors to confirm rear clearance. There are limitations to the function, detection, range and clarity of the system. The system may not detect every vehicle and may not avoid every collision. This system does not detect stationary objects. Vehicle must be in reverse and has to be travelling at 7 km/h or less. See Owner’s Manual for further details and limitations.

When the vehicle is parked, Safe Exit Warning (SEW) can alert occupants planning to exit the vehicle when a vehicle is approaching from behind. SEW does not prevent occupants from exiting. SEW may not detect every vehicle and may not avoid an accident. SEW is not a substitute for attentive operation of the vehicle. Always monitor the vehicle’s surroundings before any passengers exit the vehicle. SEW operates for approximately 3 minutes after ignition is turned off, unless doors are locked, at which time it turns off. See Owner’s Manual for important details and limitations.

Do not solely rely on Ultrasonic Rear Occupant Alert (ROA) to determine whether rear seats are empty. Always make sure you check rear seats before exiting the vehicle. Ultrasonic ROA may not detect a rear occupant in certain situations, including when little or no movement is detected or if the sensor is obscured. Never leave a child unattended in a vehicle. Please refer to the Owner’s Manual for further limitations and information regarding Ultrasonic ROA. May not be exactly as shown.